logo comp4

Impact Crusher Common Advantages And Failures

The impact crusher is a crushing equipment which sets above a variety of forces repeatedly on mine.Its impact strength should be seriously considered because it has a certain impact effect.Traditionally, the impact crusher is one of the crusher specially used in burning lime.Although the impact crusher is with the characteristics of big crushing ratio, the wearing parts is easily worn owning to the impact of the plate hammer, which causes the increasing cost of wearing parts as well as the reduction of the crushing amount.Hongxing impact crusher manufacturer has been committed to the technology innovation of jaw crusher for many years by adhering to "science and technology are the primary productive forces".At present, compared with the other crusher, our latest impact crusher has significantly improved in the stability, durability and energy saving.Hongxing impact crusher advantages: 1, large crushing ratio; the crushing ration of general crusher is less than 10.However, the crushing ratio of impact crusher is usually 30-40; the maximum can be up to 150.2, high efficiency and low power consumption.3, uniform particle size and less over milled phenomenon; 4, selective crushing; in the crushing process, the useful minerals and gangue can be crushed along the joint surface, which is helpful to monomer separation and has significantly effect on the coarse-grained minerals.5, strong adaptability;there are many common failures, so rule out the method is different.As the following, we provide four common troubleshooting methods.China cement mill:http://www.China-mills.Com/p20.Html china cone crusher:http://www.Hx-crusher.Com/cone_crusher.Html impact crusher bearing fever: 1.Indicating bearings in oil, the need for timely filling, of course, also cause excessive bearing heating fuel, refueling be sure to check the oil level, 2.Cover too tight, to regulate the bolts, elastic moderately suitable.3.Bearing damage, we must promptly replace the bearings, impact crusher out of material particle size is too large: 1.Hammer and the back plate of the gap is too large, generally adjusted to 15-20mm, 2.Indicating hammer wear, the need to hammer busy tone or replacement, 3.Feed particle size is too large will also affect the size of outputting feed.Impact crusher vibration exception: 1.Uneven wear, indicating the need to replace the hammer back, 2.Indicating material is too large, you can check the feed size.3.Basic handled properly, need to check the anchor bolts and reinforcement.4.Rotor imbalance, need to be adjusted, impact crusher belt flip: 1, because the input belt assembly issues that need to be adjusted in the same plane on the pulley, 2, indicating belt wear, in need of replacement v-belt, 3, must pay attention to the quality of v-belt itself.As the professional manufacturer of complete sets of mining machinery, such as jaw crusher, henan hongxing is always doing the best in products and service.

Chat Online