logo comp4

Technical Advantages Of The High Pressure Medium Speed Mill

A high pressure medium speed mill and other mill compared to the same and other conditions under the power output increased by 10-20%, mill roll grinding pressure of the material increased in the high-pressure spring under 800-1200kg.2, a mohs hardness of less than 9.3, mineral materials can be crushed.3, finished a wide range of particle size, the most coarse particle size of up to 0.613 mm (30 mesh) particle size usually ranging from 0.033 mm (425 mesh), a small number of materials the finest of 0.013 mm (10 mesh).4, the effect of high pressure medium speed mill dust fully meet the national standards for dust emissions.5, analysis of machine is easy to adjust.6, the high pressure medium speed mill grinding device using overlapping multi-level seal, good sealing performance.How maintenance and maintenance of cone crusher? the cone crusher in order to ensure the use of the environment is harsh, dust, combined with some use of unit maintenance is not in place, often a variety of problems in the operation, in general, the cone crusher should note the following problems in the operation, machine run.1 cone rock breaking machine at work, feeding should be uniform, not segregation.Material uneven will reduce production capacity, product size is too large, frequent spring action, the bowl bearing pressure, rising power.The cone crusher have iron removal devices to prevent the crushing chamber is too iron, if you frequently over the iron, it may be caused by a broken shaft accident.To full capacity production, otherwise there will be product granularity is too coarse.4 production lines in broken than the allocation should be reasonable, so as to maximize the efficiency of the crusher.Spring pressure is not too tight, the pressure is too large will be broken shaft accident occurs, the pressure is too small spring will frequently beat, affecting the normal working of crushers, and the product particle size coarsening.Lubricant temperature can not be too high or too low, otherwise it will affect the machine running.Lubricating oil to be changed frequently, not dirty, dirty will speed up the gear and bowl-shaped tile, bushings, wear, and even the sleeve research death.8 drive belt installation can not be too tight, otherwise it would cause the drive shaft rotation is not flexible or fracture; nor too loose, otherwise it would cause the crusher stuffy car.9 cone crusher feed can not be too wet, too sticky, fine-grained and not too much, can not be too much, otherwise it would cause a stuffy car.10 crusher discharge opening plot mine will cause a stuffy car.Ball mill [url=http://www.China-xingbang.Com/]ball mill[/url] intermittent ball mill[url=http://www.China-xingbang.Com/4.Html]intermittent ball mill[/url] [url=http://www.Xbm-aac.Com/brick_making_machine/road-edge-stonebrickmachine.Html]stone block machine[/url].

Chat Online