logo comp4

Various Methods In Mining Industry

The nature of mining processes creates a potential negative impact on the environment both during the mining operations and for years after the mine is closed.This impact has led to most of the world's nations adopting regulations to moderate the negative effects of mining operations.Safety has long been a concern as well, though modern practices have improved safety in mines significantly.Mining methods are constantly changing and improving as companies forge new technologies to enhance rates of extraction and minimise impacts such as noise, dust and land and water disturbance.There are numerous mining methods utilised around the world including open-cut mining (truck-and-shovel, strip mining, quarrying and dragline), underground mining (stoping methods, bord-and-pillar, longwall, caving methods, cut-and-fill and retreat benching) and highwall mining hammer crusher.There is a wide variety of methods of extraction which one can choose from as the orebodies have shapes and sizes.The orientation and shape of an orebody, the strength of the ore and thesurrounding rock and the form in which the valuable materials are distributed are different for each ore area.These factors among others are what will influence the selection of a mining method and the overall plan for developing the orebody.Operating mines vary in size from small underground operations (some of these operations have only a few levels of production and may produce less than 100 tonnes of ore per day) to the large open pits (some of which move thousands of tonnes or ore and waste rock per day).China magnetic separator:http://www.Hx-crusher.Com/magnetic_separator.Html cone crushers:http://www.Hxjqchina.Com/product-list_19.Html getting down to the bottom the primary opening into an underground mine can either be a shaft, a ramp (which can also be called a decline) is driven downinto the earth, or an adit which is a horizontal opening that is driven into the side of a mountain or hill.They all have the same purpose - to provide access for people, equipment and materials and to supply a way of making ore to be brought to the surface.Most of the time, shafts are vertical, but they can also be inclined, they are equipped with headframes and hoists, the headfames are the structures at the top of the hoist which enclose it.On the other hand, ramps, most of the time spiral downward at a gradient of about 15% to permit access into the mine by mobile equipment which are rubber-tired.In few cases, the ramps are driven in straight lines to accommodate conveyor belts, or they have straight runs with switch back points.Ramps are in most cases cheaper than shafts when it comes to developing.But the total cost might be higher than the cost of developing a shaft to reach the depth desired when it is dependant on the angle of the decline, the size of the opening and the encountered ground conditions.Level or horizontal mine workings are called drifts and crosscuts.At times it is useful to open vertical workings between levels in a mine which is underground; they are called winzes or raises.As the professional manufacturer of complete sets of mining machinery, such as limestone dryer, henan hongxing is always doing the best in products and service.

Chat Online